06 DNW150-2200MM Series Automatic Vertical Type Multi Points Steel Wire Shelf Welding Machine which is used for welding the steel shelf automatically.
1. Technical Data:
1.1 Welding Range:
Wire Mesh Max Width: 150-2200mm;
Wire Mesh Max Length: 150-800mm;
Cross Wire Diameter: 3.0-5.0mm;
Frame Wire Diameter: 5.0-9.0mm;
Line Wire Min spacing: 30mm(Adjustable);
Cross wire Min Spacing: 10mm(Adjustable);
Number of Pieces to be Welded(at the same time): 4 pieces of shelves with welded wire;
Frame Size: 500*800mm;
1.2 Welding Speed:
Machine Max Speed: 50-80Wires/Min
Welding One Cross Wire Time: 0.5-0.8seconds(Depends on wire diameter, excluding labor and other external factors)
1.3 Wire Material Requirements:
Mild steel wire;
Low carbon steel wire;
High carbon steel wire;
Stainless steel(S. S. ) wire;
Straight;
1.4 Machine Data:
Transformers Quantity: 4Sets
Transformers Capacity: 150kVA
Secondary Current: 32KA
Secondary Voltage 5~9V
Cylinders Quantity: 16Sets(Single)
Pressure Power: 800KG
Electrodes Width: 90mm
Each Electrode is able to weld 1-2 welding intersections
1.5 Required Supply System to run the machine:
Power supply(3-phase): 380V/50Hz+10%
Customer's Transformers Capacity: 150mm2
Molded Case Circuit Breaker: 500A
Squeezed Air: 5~8kg/cm2
Air Consumption: 300L/min
Cooling Water Volume: 120L/min
2. Machine Description
2.1 Frame Feeding System:
Loaded in 1~4pieces of steel frame to be welded manually in the central of welding machine.
2.2 Cross Wire Feeding System:
Automatic cross wire loading carriage with single wire hopper for sorting, positioning and ejecting straightened, cut to length cross wires.
2.3 Steel Shelf Mesh Welding System:
According to the wire welding pitch, the machine can adjust cylinders, electrodes, and gripping pliers. Adjustable of each point welding time and welding current for the most proper electrode stroke and perfect use of electrode dies.
2.4 Output Device System:
By means of servo motor control, cross wires fed up and welded line after line until one cycle finished. Then, servo motor returns to initial point. Unloaded welded wire frame manually.
2.5 Controlling System:
By means of P. L. C. Along with touch-off screen, all the parameters of system, and figures could be set on the screen. Besides, all abnormal signals also will show from the screen. Cross wire feeding controlled by DC servo motor; Welding machine is controlled by Thyristor and micro-computer controller. Connecting with P. L. C, The action process and wrong messages of the machine will be shown graphically.
2.6 Fault Examination System:
The machine will stop automatically when there is following faults: Wires re-supply, non-wires, fault of line wires discharging, fault of cross wires ejecting, line wire forwarding, short of welding power, overloaded of servo motor, fault fixing, squeezed air abnormal, over-high temperature.
Machine Photo
Factory Photo
Audited Supplier 
){kind=link}